Lightwave Communications SCS3230 Manuale Utente

A Lantronix Company  

 

SCS3230 System Administrator's Guide  

15.00.038

 

 - 73 - 

May 2002 

 
sys admin>>BREAK 1 
Break this connection? (write out YES) Yes or No: No>yes 
 
sys admin>> 
 

 
The 

BREAK command allows the sys admin to disconnect a user from the device port to 

which they were connected if they are in monitor, listen, or direct mode.  The user is still 
logged in after the connection is broken, but there is no longer any connection between 
the terminal port and the device port.  The sys admin must specify the terminal port 
number (as listed with the 

CONNECTIONS command) of the connection to be severed 

when using the 

BREAK command.  Pressing <ENTER> or typing NO at the confirmation 

prompt will abort the command.  To execute the command, enter 

YES at the 

confirmation prompt. 
 

 
sys admin>>FORCELOGOUT 1 
Force this user off? (write out YES) Yes or No: No>yes 
 
sys admin>> 
 

 
The 

FORCELOGOUT command causes the forcible logout of a user at any level of 

connection.  The user will be returned to the 

LCI3200> prompt after being forced off, 

and may login again unless their allowed logins are reduced to 0 before they can 
attempt another login.  When using the 

FORCELOGOUT command, the sys admin must 

specify the terminal port number (as listed with the 

CONNECTIONS command) of the 

user to be forced off.  Pressing 

<ENTER> or typing NO at the confirmation prompt will 

abort the command.  To execute the command, enter 

YES at the confirmation prompt. 

 

 
sys admin>>FORCELOGOUT SYSADMIN B 
 
Force logout sys admin? (write out YES) Yes or No: No>yes 
 
sys admin>> 
 

 
The FORCELOGOUT command may also be used to disconnect a network sys admin 
session.  The qualifiers 

SYSADMIN and the network card slot ID must be specified after 

the command.