Lightwave Communications SCS3230 Manuale Utente

ConsoleServer 3200 System  

 

Lightwave Communications 

Rev. A 

- 84 -  

www.lightwavecom.com 

 
F2 PULL-DOWN MENU SHOWING DEVICE (A.K.A. MONITOR) MODE OPTIONS 

 
                       +-------------------------+ 
                       ¦    DEVICE MODE MENU     ¦ 
                       +-------------------------¦ 
                       ¦ ENTER DIRECT MODE       ¦ 
                       ¦ CONNECT TO SERVER       ¦ 
                       ¦ DIR CONNECT TO SERVER   ¦ 
                       ¦ DISPLAY NEXT PAGE       ¦ 
                       ¦ DISPLAY PREVIOUS PAGE   ¦ 

                       ¦ GOTO BEGINING OF BUFFER ¦ 
                       ¦ GOTO END OF BUFFER      ¦ 
                       ¦ CLEAR BUFFER            ¦ 
                       ¦ FORWARD N LINES         ¦ 
                       ¦ REVERSE N LINES         ¦ 
                       ¦ CAT                     ¦ 
                       ¦ CAT WITH FILTER         ¦ 
                       ¦ EXIT FROM SERVER        ¦ 
                       ¦ DISPLAY CONNECTED LIST  ¦ 

                       ¦ LOGOUT                  ¦ 
                       ¦ DISPLAY HELP            ¦ 
                       +-------------------------+ 

 

 
If a user desires to interact directly with a server rather than only monitor its output, then they 
must enter direct mode.  To enter direct mode using the 

DIRECT command, the user must first 

select a device port as outlined in Section 7.8, Selecting a Server.  Then at the prompt, the user 
must use the command 

DIRECT or select the command ENTER DIRECT MODE from the pull-

down menu.  The user may also select a device port and enter direct mode in one step by using 
the 

DISELECT command or selecting DIR CONNECT TO SERVER from the pull-down menu.  

The 

DISELECT command must have either the device port number or the name assigned to the 

port as the command qualifier; if using the pull-down menu, a prompt box will appear to select 
the device port. 
 
The user's terminal will then be directly connected to the server, and will act as if the terminal 
was physically connected to the server.  The SCS3230 displays the last page of the device 
buffer along with a system information message indicating which device port is selected as the 
user enters direct mode. 
 

 
To escape from direct mode, the direct mode escape sequence must be used.  The direct mode 
escape sequence is a series of two to five characters that allow the user to leave direct mode 
and return to monitor mode.  The factory default for the direct mode escape sequence is 

<ESC> 

A (escape key, then uppercase "a"), but the user may change the sequence by using the 
command 

EDITESC or selecting CHANGE DIRECT MODE ESC from the pull-down menu at the 

user prompt.  It is recommended that the user only change the escape sequence if it causes 
problems with the hardware or software used.  It is also recommended that the user avoid 
combinations of the 

<CTRL> key and other keys, as these combinations are usually reserved for 

sending and receiving special characters through the terminal.  When the user changes the 
escape sequence, a window with the hexadecimal representation of the old escape sequence 
will appear.  Pressing 

<ESC> to exit from the edit prompt will not work; it will add additional