Lanner electronic FW-7650 Manuale Utente

 

         

  The default setting of Virus Warning is “Disabled”.  When it is 

enabled, any attempt to write the boot sector and partition table will halt the system and 
cause a warning message to appear.  If this happens, you can use an anti-virus utility on 
a virus free, bootable floppy diskette to reboot, to clean and to investigate your system. 

 The default setting is “Enabled”.  This speeds up 

the Power On Self Test (POST) by skipping some items that are normally checked 
during the full POST.  If your system is functioning normally, you can choose this 
feature to speed up the booting process. 

The BIOS attempts to load 

the operating system from the devices in the sequence selected in these items.  The 
settings are Floppy, LS/ZIP, HDD-0/HDD-1/HDD-2/HDD-3, SCSI, CDROM, LAN, 
and Disabled 

 The default setting is “Disabled”.  This setting gives you an 

option to swap A and B floppy disks.  Normally, the floppy drive A is the one at the end 
of the cable and drive B is at the other end.  If you set this option to “Enabled”, the Drive 
A will function as Drive B, and vice-versa under the DOS. 

This option specifies the read/write access that is 

set when booting from a Floppy disk drive. The settings are Read/Write or Read-Only. 
The Optimal and Fail-Safe default settings are Read/Write. 

 

The default setting is “On”.  If set “Off”, the cursor 

controls will function on the numeric keypad. 

 

  This setting controls the password in the main screen.  The 

options are “Setup” and “System”.  Select “Setup” and it will protect the Setup Utility 
settings from being tampered with.  Select “System” if you want to use password feature 
every time the system boots up. The default setting is “Setup”. You can create your 
password by using the “SUPERVISOR/USER PASSWORD” utility on the main 
program screen.