Ingenico iCT250 Manuale Utente
Page 3
Maintenance
Cleaning the Case
•
•
DO NOT allow any water to enter inside the case. Remove any dust from the case using a
damp cloth. To clean off accumulated dirt and grime, use a damp cloth that has previously
been dipped in mild soap and water. Wring out thoroughly to remove excess water before use.
damp cloth. To clean off accumulated dirt and grime, use a damp cloth that has previously
been dipped in mild soap and water. Wring out thoroughly to remove excess water before use.
•
DO NOT use solvents, cleaning fluids or abrasives. These materials could damage the plastic
housing and any exposed contacts.
housing and any exposed contacts.
External Power Supply
•
This apparatus is intended for use when supplied with power from a low voltage external
power supply.
power supply.
•
Only an Ingenico approved power supply (CE Marked) specified for use with this Terminal may
be used.
be used.
•
Since this product does not have a disconnect device (ON/OFF switch), the Terminal and Power
Supply must be installed near a suitable power socket which is easily accessible.
Supply must be installed near a suitable power socket which is easily accessible.
•
In the event of a hazard or malfunction, the Power Supply Unit should be switched off at the
socket before being unplugged from the mains.
socket before being unplugged from the mains.
•
The power supply output lead should only be plugged into the product power input socket.
•
The power supply will provide adequate power for the Terminal. The user should ensure that
all other auxiliary apparatus, drawing power from the host, does not overload the power
supply.
all other auxiliary apparatus, drawing power from the host, does not overload the power
supply.
•
Operate only a from a power source as specified on the Power Supply Unit.
A damaged mains cord (if not a replaceable type) or low voltage secondary input lead cannot be
replaced by the user, the unit must be returned to the authorised service agent for essential repairs
and/or replacement.
replaced by the user, the unit must be returned to the authorised service agent for essential repairs
and/or replacement.
Connections
Interconnection to other equipment via the externally accessible ports on the Terminal must only be
made as follows:
made as follows:
Power Supply Input: Operates at Safety Extra Low Voltage (SELV). Connect only to an Ingenico
approved Power Supply (CE Marked) specified for use with the Terminal.
approved Power Supply (CE Marked) specified for use with the Terminal.
Port(s), 6 way: The RS232 type port(s) operate at SELV and must only be connected to a module of
the same type ie. SELV.
the same type ie. SELV.
Public Switched Telephone Network (PSTN) Line, 6 Way: MUST only be connected to a PSTN socket
e.g. Telephone wall socket, PBX etc.
e.g. Telephone wall socket, PBX etc.
Under no circumstances must the PSTN cable be inserted into the RS232 ports. Take due care when
attaching cables.
attaching cables.