Hunter Engineering Quick Tread Foglio Delle Specifiche
Quick Tread - Stand Alone
Flush Mounted
For inspection information visit:
www.hunter.com/inspection
For local contact visit:
www.hunter.com/company/findrep.cfm
For general inquiries visit:
www.hunter.com
or call
800 448-6848
Form 6897-T, 05-15a
Copyright © 2015, Hunter Engineering Company
Stand-Alone Flush Mount Quick
Tread Installation
Continued on Page 2
12 ft.
RECOMMENDED
BAY WIDTH
OPTIONAL
PEDESTAL
LOCATION
OVERALL FOOTPRINT
QUICK TREAD COMMUNICATION CABLES (UP TO 75 ft.)
4 in.
51 in.
22 ft. 5 in.
TYPICAL
93 in.
(7 ft. 9 in.)
Site Specifications
Power Requirements
115/230v, 15 amp
*
50/60 Hz 1 ph
Ɨ
Air Supply Req. (IS Units)
90-150 PSI (6.2-10.3 bar)
Approximate Air
Consumption
25 SCFM @ 90 PSI
(648 Lpm @ 6.2 bar)
Substructure Specifications
Refer to Form 6905-T
Pedestal Location
36 - 96 in. (914 - 2438 mm) from QT1F
Product Specifications
Max. Wheel Weight
3500 lb. (1588 kg) per wheel
Test Entry Speed
2 to 8 mph (3-13 km/h)
Shipping Weight
Quick Check Cabinet
290 lbs (132 kg)
Quick Check Drive Under
Sensor
316 lbs (143 kg)
Quick Tread
1723 lbs (455 kg)
*
Amperage shown is minimal circuit rating.
Ɨ
Isolated ground recommended.