Eclipse Combustion EGA4 Manuale Utente

 
 
 

Instruction Manual MM850481 ed.01 

Smoke index measurement is done by using a hand pump (supplied as an accessory), the results cam be memory 
stored and printed in the report. 

A remote Pt100 probe is available for combustion air temperature measurement from –10°C to 100°C. This probe is 
strongly recommended mainly in forced air boiler to obtain an accurate calculation of the efficiency. 

Optional probe for simultaneous measurement of ambient temperature and relative humidity (%RH) for comfort index 
computation. 

Optional probe to monitor CO concentration and therefore safety condition in the boiler room. The instrument gives 
acoustic and visual alarm if the set limit (according to the OSHA recommendation) are exceeded.    

Optional probe to monitor CH

4

 and natural gas concentration and detect and locate the position of a gas leak into the 

domestic pipe network. 

To check gas network tightness using a pressure decay method at programmable interval time. It uses the internal 
pressure sensor and a Eclipse leakage procedure. 

A 1 meter 8x4mm silicon hose is used to check the pressure inside the burner when you are installing the heating 
system. 

The EGA4 analyzer can be connected to a Pitot tube for gas speed measurements. 

Each  EGA4 portable gas analyzer, is factory calibrated and certified against Eclipse Standards, that are periodically 
certified by an International recognized Laboratory, and shipped with a Report of Calibration stating the nominal and 
actual values and the deviation errors. 

9