Garmin Vector S Guida All'Installazione Rapida

Read all instructions carefully before installing and using the 

Vector™ system. Improper use could result in serious injury.
See the Important Safety and Product Information guide in the 

product box for product warnings and other important 

information.

Go to 

 for the latest information 

including bike compatibility, software updates, and video 

tutorials.

• 15 mm pedal wrench
• Bike grease
• 3 mm hex key
• 4 mm hex key

Confirm the compatibility of your bike at 

.

Remove the existing pedals.

Clean the threads, and remove old grease.

The pedal pod should contact the crank arm only at its mounting 

face, because this is the load-bearing connection. If the pedal 

pod contacts the crank arm anywhere else, the pedal pod may 

fracture when the pedal is tightened.

• If the mounting face 

À

 surrounding the threaded hole in the 

crank arm is recessed, use one or two washers 

Á

 to fill the 

recess.
NOTE: Do not use more than two washers.

• Make sure the pedal pod mounting face 

Â

 contacts the crank 

arm only at its mounting face (or the washer used to fill the 

recess).
If it touches anywhere else, you can use another washer to 

provide the necessary clearance.

• If it is close, you can confirm proper clearance by sliding a 

piece of paper between the metal bracket and the crank arm 

face.

• If the mounting face of the crank arm is protruding, do not 

use washers.

NOTE: The left and right pedal pods are the same.

Install the left pedal first.

Apply a thin layer of grease on the pedal spindle 

À

 and the 

pedal pod 

Á

 where it contacts the pedal spindle.

On the pedal spindle, stack the pedal pod and any required 

washers 

Â

.

TIP: You must carefully bend the cable 

Ã

 out of the way.

Insert the spindle into the crank arm 

Ä

.

Hand tighten the spindle.
NOTE: The left pedal spindle has a left-handed (reverse) 

thread.
TIP: Power and cadence calculations are not impacted by 

the orientation of the pedal pod. Garmin

®

 recommends 

placement of the pedal pod on the leading edge of the crank. 

When the crank is in the forward position, the pedal pod 

should be pointing downward.

Rotate the crank arm to check for clearance.
The pedal pod should not interfere with any part of the bike.

Use the pedal wrench to tighten the spindle.
NOTE: Garmin recommends torque of 25 to 30 lbf-ft. (34 to 

40 N-m).

Firmly plug the cable into the spindle.

Rotate the crank arm to check for clearance.

Repeat steps 2–9 to install the right pedal.
NOTE: If the pedal pod cable rubs the chain, you can add 

one or two washers between the pedal pod and the crank 

arm to increase clearance.

NOTE: The left and right cleats are the same.

Apply a thin layer of grease on the cleat bolt threads.

Align the cleat 

À

, washers 

Á

, and bolts 

Â

.

Use a 4 mm hex key to loosely attach each bolt to the sole of 

the shoe.

Adjust the cleat to the shoe in your preferred position.
This can be adjusted after a trial ride.

Tighten the cleat firmly to the shoe.
NOTE: Garmin recommends torque of 4 to 6 lbf-ft. (5 to 8 N-

m).

2