Char-Broil 463243812 Manuale Utente

Follow these instructions to clean and/or replace parts of burner
assembly or if you have trouble igniting grill.
1.  Turn gas OFF at control knobs and LP cylinder.
2. Remove cooking grates and flame tamers. 

3.

Remove carryover tubes and burners.

4.

5.

Carefully lift each burner up and away from valve openings.

We suggest three ways to clean the burner tubes. Use the one
easiest for you.

(A) Bend a stiff wire (a light weight coat hanger works well) 

into a small hook. Run the hook through each burner 
tube several times.

(B) Use a narrow bottle brush with a flexible handle (do not 

use a brass wire brush), run the brush through each 
burner tube several times.

(C) Wear eye protection: Use an air hose to force air into 

the burner tube and out the burner ports. Check each 
port to make sure air comes out each hole.

6.

Wire brush entire outer surface of burner to remove food 
residue and dirt.

7.

Clean any blocked ports with a stiff wire such as an open 
paper clip.

8.

Check burner for damage, due to normal wear and corrosion 
some holes may become enlarged. If any large cracks or 
holes are found replace burner.

 9. Attach electrode to burner.
10. Carefully replace burners.
11. Attach burners to brackets on firebox.
12. Reposition carryover tubes and attach

to burners. Replace flame tamers and
cooking grates.

• Clean cooking grates.
• Store in dry location.
• When LP cylinder is connected to grill, store outdoors in a well-

ventilated space and out of reach of children.

• Cover grill if stored outdoors. Choose from a variety of grill 

covers offered by manufacturers.

• Store grill indoors ONLY if LP cylinder is turned off and 

disconnected, removed from grill and stored outdoors.

• When removing grill from storage, follow “Cleaning the Burner 

Assembly” instructions before starting grill.

In some areas of the country, spiders or small insects have been 
known to create “flashback” problems. The spiders spin webs, build 
nests and lay eggs in the grill’s venturi tube(s) obstructing the flow of 
gas to the burner. The backed-up gas can ignite in the venturi behind 
the control panel. This is known as a flashback and it can damage 
your grill and even cause injury.

To prevent flashbacks and ensure good performance the burner and 
venturi assembly should be removed from the grill and cleaned 
before use whenever the grill has been idle for an extended period.

Detach electrode from burner. 

NOTE: Removal/Detachment method will depend on the 
burner configuration. See different configurations in 
illustrations below.

Pry off 
electrode with 
a flat blade 
screwdriver

9