Avaya Media Gateway G700 Manuale Utente

3. Close the screen.

If the primary server has LSPs, you must enter the LSP node names on the LSP form to enable 
the LSPs to get translations updates from the primary controller. Once the LSPs are 
successfully entered on the LSP form, their status can be viewed with the list 
survivable-processor 

command.

Note:

The LSP node names must be administered on the node-names-ip form before 
they can be entered on the LSP form.

1. At the SAT command line, type add survivable-processor <name>, where <name> 

is the LSP name from the Node Names screen. 

The Survivable Processor screen appears.

The threshold for the number of sockets used by this 
C-LAN within the same Gatekeeper Priority as that of 
other IP interfaces. If the targeted number is exceeded 
on a CLAN, a warning alarm is generated. If the targeted 
percentage is exceeded on an PE interface, a procr error 
is generated.

Enter a ’y’ to allow H.323 endpoint connectivity on this 
CLAN. Enter ’n’ if you do not want H.323 endpoints to 
connect to this CLAN.

Enter ’y’ to allow H.248 gateway connectivity to this 
CLAN. Enter ’n’ if you do not want H.248 gateways to 
connect to this CLAN.

This value is used on the alternate gatekeeper list. The 
lower the number the higher the priority. Valid values for 
this field are one through nine with five being the default. 
This field displays only if the allow H.323 endpoints field 
is set to a yes on this form.