Digidesign Control 24 Manuale Utente

When you have confirmed a send assignment, 
the SWITCH ACTIVE LEDs will light up below 
the encoder switches that correspond to that 
send’s destination and the panning information 
should show up in the scribble strips. 

Send Level and Mute Controls

The encoder knob below the send destination 
strip functions as the send level control. The re-
spective scribble strip briefly displays the send 
level information and then reverts back to the 
send destination information.

The corresponding encoder switch below this 
knob functions as a Send Mute toggle control. 
The respective scribble strip briefly displays 
“Mute” when muted and then reverts back to 
the send destination information.

When muted, this encoder switch LED will 
light. See “Muting Sends” on page 105 for more 
information about muting Sends.

Send Panning and Pre/Post Control

The next scribble strip, to the right of the send 
destination indicator, displays panning infor-
mation for the send. The encoder knob below 
the scribble strip adjusts panning.

The associated encoder switch serves as a pre- or 
post-fader toggle for the send (lit if pre-fader). 

To assign a Send from Pan/Send mode:

1  

Press the PAN/SEND switch on a channel to 

display its Sends in the Channel Bar.

2  

To page the Channel Bar display between 

Sends A–E and Sends F–J, press the left and right 
Channel Bar Scroll switches.

3  

Press the ASSIGN switch in the ASSIGNMENT 

section. 

4  

For each send where you want to make an as-

signment, turn the channel data encoder to 
scroll through the available path choices. 

5  

Press the flashing switch below an encoder to 

confirm the corresponding Send assignment.

6  

Press the ASSIGN switch to confirm all assign-

ments.

Shortcuts

To make the same output assignment to selected 
channels only:

1  

Press the PAN/SEND switch on a channel.

2  

Press the ASSIGN switch in the ASSIGNMENT 

section.

3  

Turn the channel data encoder to scroll 

through the available path choices.

4  

While holding APPLY TO ALL SELECTED 

CHANNELS or OPT(ALT)/ALL+SHIFT/ADD, con-
firm the assignment by pressing the flashing 
switch directly below the channel encoder, or 
pressing the ASSIGN switch.