Brother NC-2200W Manuale Utente
NETWORK SCANNING FROM WINDOWS
®
5 - 4
NC9100h_FM6.0
Setting up the Network Scanning Software
STEP 1: Install the MFL-Pro Suite using the CD-ROM
supplied with your MFC/DCP
supplied with your MFC/DCP
This software is included on the CD-ROM supplied with your MFC/
DCP. To install the software, follow the steps in ‘Installing the Driver
& Software for Network Interface Cable Users’ section of the Quick
Setup Guide included with your MFC/DCP.
DCP. To install the software, follow the steps in ‘Installing the Driver
& Software for Network Interface Cable Users’ section of the Quick
Setup Guide included with your MFC/DCP.
During the MFL-Pro Suite software installation you may see
the following screens.
the following screens.
■
For MFC-8420/8820D/8820DN/8220/8440/8840D/
8840DN3820CN/3420CN and DCP-8020/8025D/8025DN/8040/
8045D/8045DN
When this screen is displayed in the installation process, select
No and then click Next
8840DN3820CN/3420CN and DCP-8020/8025D/8025DN/8040/
8045D/8045DN
When this screen is displayed in the installation process, select
No and then click Next
.
■
Some MFC/DCPs with the NC-2200w cannot be found in the
search list during installation. In that case go back to the screen
shown below and set the node name of the NC-2200w manually.
You can see the node name on the Network Configuration page,
see
search list during installation. In that case go back to the screen
shown below and set the node name of the NC-2200w manually.
You can see the node name on the Network Configuration page,
see