Brother NC-2200W Manuale Utente

TROUBLESHOOTING 6 - 2

Make sure that the Link LED is turned on. If the Link LED is not 
turned on, Brother NC-2200w may not work properly. Check the 
following:

Check if the Brother NC-2200w power is turned on.

Check if the Brother NC-2200w is securely connected to the 
Brother Printer/MFC/DCP and the Printer/MFC/DCP is powered 
on.

Move your PC closer to the Brother Printer/MFC/DCP with the 
NC-220w installed and try gain 

Reset the NC-2200w back to the default setting and try again. 
For the information how to reset to the factory default setting, 
see Test Button on page 1-4.

Before you configure the NC-2200w, you need to temporarily change 
your computer’s wireless settings to communicate with the un-
configured NC-2200w. Check following:

Check if the wireless settings of your computer are as follows.

■

Communication mode: Ad-hoc (channel 11) 

■

Network name (SSID/ESSID): SETUP (case sensitive)

■

Encryption               : None

If you are using Windows

® 

XP or Mac OS

®

 X 10.2.4-10.3 or 

greater, and the Ad-hoc network “SETUP” doesn’t appear in the 
available network list of the wireless setup utility of the 
Windows

® 

XP or Mac OS

®

 X, you may be able to resolve this 

problem by manually adding the Ad-hoc network using the 
following procedure.