Benq PB9200 Manuale Utente
Network Setting Up
35
Network Setting Up
This projector provides the NETWORK function. When you start to use this function,
please consult your dealer for further information.
please consult your dealer for further information.
To start, connect the NETWORK port to a gateway device via a CAT-5 cable, then set up the
projector according to the Network environment in which you use it.
projector according to the Network environment in which you use it.
When your Network enables the DHCP function
You can set automatically, if you set the DHCP function to "TURN ON" using the NET-
WORK menu. Please refer to the section "NETWORK Menu".
You can set automatically, if you set the DHCP function to "TURN ON" using the NET-
WORK menu. Please refer to the section "NETWORK Menu".
When your Network doesn’t support the DHCP function or When you use a fixed
address even if your Network can support the DHCP function
Please set the IP Address, the Subnet Mask, the Default Gateway and the DHCP using the
NETWORK menu. At first, set the DHCP function to “TURN OFF”.
address even if your Network can support the DHCP function
Please set the IP Address, the Subnet Mask, the Default Gateway and the DHCP using the
NETWORK menu. At first, set the DHCP function to “TURN OFF”.
You can set them using a Web Browser (Internet Explorer 4.0 or higher) on the computer
connected to the Network.
connected to the Network.
Input the same IP address as set to the projector onto the Web Browser on the computer
connected to LAN.
ex. Case of IP Address = 192.168.1.11
1.
1.
Input “http://192.168.1.11”.
2.
Click “ENTER”.
3.
Input the required data according to
the screen.
the screen.
4.
Make sure of the input data, then click
"Write".
"Write".
memo
These setting will be active after
reboot. These setting will be stored, and used
when DHCP is OFF.
when DHCP is OFF.
5.
Click “Return to top page”.
6.
Click “REBOOT” to complete this
operation.
operation.
PB9200-e.book Page 35 Thursday, May 27, 2004 2:15 PM