Welch Allyn Medical Diagnostic Equipment Medical Alarms 8.1x Manuale Utente
4
43
Adjust monitoring settings and
patient information
patient information
Set up typical monitoring at the Virtual Monitor
This table presents typical monitoring functions that you can set up at the Acuity Central
Station using the Virtual Monitor.
Station using the Virtual Monitor.
Table 2. Typical monitoring functions at the Virtual Monitor
NIBP and SpO
2
spot checks
Task
Clicks at Virtual Monitor
Notes
Start an NIBP
measurement (except for
a Micropaq monitor).
measurement (except for
a Micropaq monitor).
1. NIBP,
2. START
2. START
Can be started also at the patient monitor.
(Propaq LT monitor) Start
an SpO
an SpO
2
spot check
measurement.
1. SpO
2
,
2. START
SpO
2
Spot Mode must be turned on at the monitor.
Patient mode and alarms
(Micropaq monitor)
Change the patient mode.
Change the patient mode.
1. MAIN MENU
2. MORE
3. MORE
4. NEXT
5. CHANGE
2. MORE
3. MORE
4. NEXT
5. CHANGE
You can change a Micropaq monitor’s patient mode only at
the Acuity Central Station. For all other patient monitors, you
can change patient mode only at the patient monitor.
the Acuity Central Station. For all other patient monitors, you
can change patient mode only at the patient monitor.
WARNING Always check patient mode in the
border of the Waveform Window or Virtual Monitor.
Incorrect patient mode can result in unsuitable
alarm settings, inaccurate heart rate readings and
inappropriate arrhythmia and ST-segment analyses.
border of the Waveform Window or Virtual Monitor.
Incorrect patient mode can result in unsuitable
alarm settings, inaccurate heart rate readings and
inappropriate arrhythmia and ST-segment analyses.
Temporarily suppress the
potential for audible
alarm tones.
potential for audible
alarm tones.
1. SUSPEND
2. When ready to return to
2. When ready to return to
normal monitoring:
RESUME
RESUME
Although any alerts for this patient are displayed, SUSPEND
suppresses alert tones for 90 seconds.
suppresses alert tones for 90 seconds.