Wayne-Dalton 341458 Manuale Utente

Tools Needed:

Please Do Not return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local 

yellow pages business listings or go to the Find a Dealer section 

IMPorTANT: REaD INsTRuCTIONs TITlED “P4” “REMOVING THE OlD DOOR” ON PaGE 9 aND “P5” “PREPaRING THE OPENING” ON 
PaGE 10 BEFORE aTTEMPTING DOOR INsTallaTION.

IMPorTANT: sTaINlEss sTEEl OR PT2000 COaTED laG sCREWs MusT BE usED WHEN INsTallING CENTER BEaRING BRaCkETs, 
END BRaCkETs, jaMB BRaCkETs, OPERaTOR MOuNTING/suPPORT BRaCkETs aND DIsCONNECT BRaCkETs ON TREaTED luMBER 
(PREsERVaTIVE-TREaTED). sTaINlEss sTEEl laG sCREWs aRE NOT NECEssaRy WHEN INsTallING PRODuCTs ON uN-TREaTED 
luMBER.

NoTE: It is recommended that 5/16” x 1-5/8” lag screws be pilot drilled using a 3/16” drill bit, and 1/4” x 2” lag screws and 
1/4” x 1-1/2” lag screws be pilot drilled using a 1/8” drill bit, prior to fastening. 

None

NoTE: If you have fully adjustable 
flagangle, skip this step and complete 
step 2. 

Place the lower quick install tab of the 
flagangle in the quick install feature of 
the vertical track. Give the flagangle 1/4 
turn to lock in place. Repeat for other 
side.

NoTE: after completing this step, 
continue with step 3.

quICk INsTall TaB uNlOCkED

quICk INsTall TaB lOCkED

FlaGaNGlE

VERTICal 

TRaCk

lEFT HaND TRaCk aND FlaGaNGlE 

RIGHT HaND TRaCk aND FlaGaNGlE 

FlaGaNGlE

VERTICal 

TRaCk