Wayne-Dalton 341458 Manuale Utente

Tools Needed:

Tools Needed:

Please Do Not return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local 

yellow pages business listings or go to the Find a Dealer section 

Position the horizontal angle as shown. 
Place tabs of horizontal angle in the 
key slots of horizontal track. using 
a hammer, tap the horizontal angle 
towards the curved end of the track until 
the holes in track and angle are aligned. 
set tracks aside.

NoTE:  For  larger  doors,  a  full  length 
horizontal angle may be spot welded to 
the horizontal track. If the horizontal angle 
is not welded, the horizontal angle will be 
installed as shown.

Hammer

HORIzONTal 

TRaCk

HORIzONTal 

aNGlE

HORIzONTal aNGlE

HORIzONTal 
TRaCk

HOlE

HOlE

TaBs

kEy slOT

HORIzONTal 

TRaCk

TaBs

HORIzONTal 

TRaCk

HORIzONTal 

aNGlE

HaMMER

HOlEs 

alIGNED

1/4”- 20 

FlaNGE HEx 

NuTs

NoTE: If quick install flagangle was 
installed in step 1, skip this step and 
continue with step 3. If not, complete 
this step.

Hand tighten the flagangle to the vertical 
track using (2) 1/4” - 20 x 9/16” large 
head ribbed track bolts (or stud plate if 
included) and (2) 1/4” - 20 flange hex 
nuts. Repeat for other side.

secure the flange nuts after flagangle 
spacing is complete (step 12).

Fully aDjusTaBlE FlaGaNGlE

1/4” - 20 x 9/16” 

laRGE HEaD RIBBED 

TRaCk BOlTs

None

VERTICal TRaCk

sTuD PlaTE 

(IF INCluDED)