Hughes AN6-098P Manuale Utente

 

Secure the feed support tube:

1. Attach the lower ends of the feed rods to the feed support 

tube as follows: Insert the ¼-20 × 2-inch hex bolt through the 
tube, and use the hardware shown in Figure 19.
Make sure the flat end of the feed support tube points toward 
the reflector.

2. Tighten the nut just enough to keep the hardware in place. 

3. Attach the flat end of the feed support tube to the rim of the 

reflector, as shown in Figure 20.

4. Tighten the nut just enough to keep the hardware in place. 

Figure 19:  Attaching the feed rods to the feed support tube

T0172007

¼-20 x 2-inch

hex bolt

¼-inch

flat washer

¼-inch

flat washer

¼-inch lock

washer

¼-inch hex nut

Feed rod

Feed rod

Feed

support

tube

Detail 

Feed rod ends attached to feed 

support tube, in front of reflector

Figure 20:  Attaching the feed support tube to the reflector rim

T0172008

¼-20 x 1-inch

hex bolt

¼-inch flat washer

¼-inch flat washer

¼-inch lock washer

¼-inch hex nut

Feed
support
tube

Reflector rim

Back of 
reflector

Detail 

Flat end of feed 
support tube

Rim