Hughes AN6-098P Manuale Utente

 

Tighten the hardware as follows:

1. Tighten the three nuts on the reflector rim (indicated by the 

black arrows in Figure 21).

2. Tighten the nut where the feed rods attach to the feed support 

tube (indicated by the white arrow in Figure 21). 

The antenna is now assembled, as shown in Figure 22, and ready 
for installation of the radio assembly.

• If you are installing a J-type radio, go to Chapter 4 – 

• If you are installing a cradle-type radio, go to Chapter 5 – 

Installing a cradle-type radio assembly, on page 43. 

Figure 21:  Tightening nuts on feed rods and feed support tube

Figure 22:  Completed antenna assembly (without radio)