Hughes AN6-098P Manuale Utente

 

2. Apply silicone grease to the O-ring groove in the feed horn.
3. Place the O-ring (0.9-inch inside diameter) in the groove. 

Make sure the O-ring remains in the O-ring groove. 

Use the mounting adapter to attach the radio assembly to the feed 
support tube. Refer to Figure 36 as you follow these instructions:

1. Place the mounting adapter and radio assembly onto the feed 

support tube.

2. Align the mounting holes in the base of the radio assembly, 

mounting adapter, and feed support tube.
There are six holes on the top surface of the feed support 
tube. Use the oval slot at the end of the tube and the second 
hole from the bend in the tube, as shown in Figure 36.

3. From below, insert two 

5  

⁄

16

-18 × 2.25-inch hex bolts (using a 

5  

⁄

16

-inch lock washer and flat washer on each bolt) through 

the feed support tube, adapter, and base.

Note:

The O-ring is shipped in a bag that contains seven 

socket-head cap screws for attaching the feed horn. Six screws 
are required; one is an extra part.

Figure 35:  O-ring in groove

O-ring