Hughes AN6-098P Manuale Utente

 

Route the coaxial transmit and receive cables at the ODU as 
follows:

1. Route the transmit cable (marked with blue electrical tape) 

over the Az/El and reflector bracket assembly and behind the 
reflector to the back of the transmitter, in a configuration 
similar to that shown in Figure 38.
Do not exceed the minimum bending radius specified by the 
cable manufacturer. 

2. For the transmit cable, leave a 152-inch service loop (12 ft 

8 inches), secured to the mast, or Az/El mount assembly. This 
allows 10 ft for a service loop plus 32 inches for installation 
of a future Ka-band radio upgrade.
Do not leave the service loop on the roof or other mounting 
surface.
Do not block access to the adjustment nuts on the canister 
and Az/El mount assembly.

Figure 38:  Transmit and receive cable configurations

T0172016

Transmitter

Transmit cable

(marked with

BLUE tape)

Receive cable

(marked with

RED tape)

Radio

Do not exceed the
cable bending radius.

Secure cables with
cable ties (not shown).

Service loops for transmit and
receive cables. Coiled, with drip loops.