Hughes AN6-098P Manuale Utente

 

This section explains how to connect the transmit and receive 
cables to the radio assembly.

Connect the transmit cable to the transmitter as follows:

1. From inside the building, disconnect the IDU power supply.
2. Go outside and connect the transmit cable (marked with blue 

electrical tape) to the transmitter connector marked IFL.
Figure 41 shows the transmit connector location for the 
J-type radio assembly, and Figure 42 shows the connector 
location for the cradle-type radio assembly. In both cases the 
connector is a female F connector.   

3. Use a 

7

/

16

-inch torque wrench to tighten the connector to 

20 inch-lb

.

Figure 40:  Ground screw on cradle-type radio assembly (arrow)

(Not used)