Hughes AN6-098P Manuale Utente

 

To prepare for antenna pointing, attach the OPI to the receive 
cable from the LNB, as shown in Figure 46. Note that the OPI 
will not work unless it is enabled on the appropriate screen on the 
installation software. (Check the box labeled 

Enable OPI 

Display

.) For further details, see Outdoor Pointing Interface 

Operating Instructions (1031832-0001). 

OPI block If you use an OPI with a model J-type radio assembly, you must 

use a block (or filter). For details, including the specific block you 
should use, see the Hughes Field Service Bulletin (FSB), 
Standard OPI Configuration (FSB_060915_01A).

Install the block between the OPI and the radio as illustrated in 
Figure 46. If the block you use has two female F connectors (at 
both ends), you will have to make a jumper cable to connect to 
the OPI.

Figure 46:  OPI

T0172001

Hughes

Net

Block

(if required)

IDU

LNB