Hughes AN6-098P Manuale Utente

 

The antenna pointing procedure begins with the steps described 
in this section and continues through the end of this chapter. 
Follow the instructions in the order they are presented. 

Set the initial (coarse) antenna elevation to the initial elevation 
value given by the installation software, as follows:

1. Loosen the two fine elevation adjustment nuts indicated in 

Figure 49 so the antenna reflector can move forward and 
backward.

2. Loosen the two elevation lockdown 

bolts

 indicated in 

Figure 49, a little at a time, until you can rotate the antenna 
reflector forward and backward to adjust the elevation.   

3. Set the elevation to the value given by the installation 

software. 

Note:

Do not tighten the elevation lockdown bolts yet 

because you will be adjusting elevation further, as explained 
in Fine elevation adjustment on page 62.

Figure 49:  Setting coarse elevation

Elevation scale

Elevation lockdown bolts (2)

Fine elevation 
adjustment nuts