HP Latex 260 61-in Japan Printer (Designjet L26500 61-in Japan Printer) Manuale Utente

The printer is designed to be used with rolls of substrate. It is possible to load cut sheets into the printer,

but print quality cannot be guaranteed, and you may have some difficulty in avoiding skew.

●

The sheet should be at least 1067 mm (42 in) long.

●

Load the sheet by following the normal roll loading process (automatic or manual, depending on

the substrate).

●

During the loading process, the printer tries to detect the winding direction of the roll by turning

the spindle in both directions. When the substrate is not attached to the spindle, the following

message appears.

To continue loading, select Skip check – would affect IQ.

●

A cut sheet is likely to be loaded with excessive skew, and the printer may not be able to correct it

automatically. If the skew as measured by the printer exceeds 3 mm/m, you are recommended to

stop loading and try again. However, if the skew is tolerable, you can consider skipping the

automatic skew correction. To do so, when prompted, choose Continue with current skew.

If you used the take-up reel during printing, unload the printed roll from the take-up reel. See

.

On the printer's front panel, select the   icon, then select Substrate unload > Unload roll.

Press the 

OK

 button on the front panel as many times as needed to rewind the substrate.

Lift the spindle lock lever.

ENWW

Load a cut sheet into the printer

33