HP Latex 260 61-in Japan Printer (Designjet L26500 61-in Japan Printer) Manuale Utente

Remove the roll from the printer, pulling out the right end on the right side of the printer first. Do

not insert your fingers into the spindle supports during the removal process.

The take-up reel must be enabled and operated from the front panel. When the take-up reel is enabled,

the “Take-up reel enabled” message appears on the Substrate tab on the front panel. If the take-up

reel is not enabled and you would like to enable it, select the   icon, then select Take-up reel >
Enable take-up reel.

When in use, the take-up reel requires a dangling loop of substrate weighed down by a loop shaper.

There are two different loop-shapers provided with the printer, to be used with different substrate types.

●

The heavy loop-shaper is used with banner, textile and mesh substrates. It is attached to supports

on either side of the substrate. The spindle stops should not be used with this loop-shaper.

34

Chapter 4   Handle the substrate

ENWW