Chauvet Baby Accessories ST-800X Manuale Utente

 

ST-800X User Manual   

11 

 

2007-03-07

/

10:58 

SPEED 

DIM

SPEED 

DIM 

DMX Out 

DMX In 

•  A stand-alone mode will allow the user to set the desired speed and intensity. 
•  Master/Slave output provides for unison triggering of chained strobes. 
•  DMX-512 control protocol allows remote control of the fixture via a universal DMX controller. 

The Stand Alone mode is activated automatically when the fixture is absent of a CH-751, SC-1000M 

or a DMX controller. Note! All dipswitches 

must be set to the OFF position. The 

strobe speed and strobe intensity can be 

adjusted and they are located on the side 

of the fixture. The strobe will continue to 

operate at the user set levels until it is 

turned off. Upon turning the strobe back on 

the unit will continue in the previously set levels. 

The Unison strobe mode will allow you to link additional units in a daisy chain fashion. Simply, 

connect each fixture in a daisy like fashion using certified DMX XLR cable. Be sure that all DMX 

dipswitches are set to the OFF position.  

 

In this mode the user can control the strobe light remotely. Both the intensity and the flash rate can be 

programmed as part of a scene or a cue. To blackout the unit entirely it requires both intensity and 

flash rate to be at 0 levels. 

1.  Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector 

of the controller. 

2.  Connect the end of the cable coming from the controller which will have a (female) 3 pin connector 

to the input connector of the next fixture consisting of a (male) 3 pin connector.  

3.  Then, proceed to connect from the DMX output as stated above to the DMX input of the following 

fixture and so on. 

4.  If you need help setting the DMX address read the section titled “Setting the DMX address” in this 

Chapter.