Braun Mobility Aid RA200 Manuale Utente

Page 14

Ramp Skid Pad          Guide Rail          Slide Tube

Ramp Skid Pad Contacting Top of Guide Rail

2 MM

2 MM

Floor Level Sensor

Stow Level Sensor

1. The floor level (up) sensor pick-up (see Photo 

H) should be adjusted (via the set screw) 
so that the elevation motor stops once the 
platform has gently touched against the 
top cover lip (see Photo G on page 13 ), or 
vehicle threshold if further from the center of 
the vehicle.  Incorrect setting of this pick-
up could result in a large gap between the 
platform and the threshold (too low) or in the 
ramp retracting into the stowed position due 
to obstruction sensing (too high). 

2. The stow level (down) sensor pick-up (see Photo 

I) should be set (via the set screw) to allow a 
smooth transition of the ramp platform into the 
cassette.  Ramp skid pads, located on the back 
corners of the ramp (see Photo J), reduce friction 
at the point where the ramp corners contact the 
top of the guide rail.  See Photo K.  Carefully ob-
serve the ramp skid pads when adjusting the stow 
level sensor pick-up.  Note:  An incorrect setting 
of the stow level could result in excessive wear, 
premature failure, or the shearing off of the ramp 
skid pads (pads are replaceable).

Set Screw

Floor Level Pick-Up

Set Screw

Stow Level Pick-Up

  Exterior Adjustments (continued)