Braun Mobility Aid RA200 Manuale Utente

Page 15

Front Cover

Ramp Toe

Maximum Setting 

Toe of Ramp 

Contacts Cover

2. When decreasing the height, the non-used 

portion of the threaded studs must be cut off 
to maintain proper clearance for main axle 
rotation (see Photo N).  Failure to do so may 
result in the inability of the platform to lower 
to stow level due to a binding condition of the 
main axle, possibly causing damage to the 
elevation motor.

Cut off excess threads.

Floor Height:  Variable height adjustments are 
made by screwing the four threaded bar ramp 
supports in/out to achieve the desired floor level 
height.  Once initially set during installation, this 
height should not require altering.  Two items to 
note.

1. When increasing the height, the maximum 

is achieved when the ramp toe contacts the 
inside of the front cover (see Photo M).  If the 
maximum is surpassed, the front cover will 
remain partially open when the ramp is in the 
fully  stowed position, thus allowing foreign 
material and debris to enter the cassette.

Lift ramp to access bolts.

  Exterior Adjustments (continued)