Marvel 8SWCEL Istruzione Sull'Installazione

The proper location will ensure peak performance of your ap-

pliance.  We recommend a location where the unit will be out 

of direct sunlight and away from heat sources.  To ensure your 

product performs to specifications the recommended installation 

location temperature range is from 55 to 100°F (13 to 38°C).

Only the 6OSWCE model is suitable for outdoor installations. 

Building codes may require a ground fault circuit interrupter 

electrical receptacle to supply electrical power to the refrigerator 

for outdoor applications, (see “Electrical Connection” section). 

Do not install in an environment where the unit will be exposed 

to direct sun exposure as this may result in unsatisfactory perfor-

mance.

Ventilation is required from the bottom front section of the unit.  

Keep this area open and clear of any obstructions.  Adjacent 

cabinets and counter top can be installed around the unit as long 

as the grille and door access remain unobstructed.   

Leveling Legs

Front Grille, keep 

this area open.

Figure 2

Figure 3

Rear of unit

with access 

cover removed

Rear leveling legs 

at outside corners

Center rear leveling leg 

on 30” wide units only

Adjustable legs at the front and rear corners of the unit should 

be set so the unit is firmly positioned on the floor and level from 

side to side and front to back. The overall height of your Marvel 

refrigerator may be adjusted from 33-3/4” (85.7cm) with the lev-

eling legs turned in, and up to 34-3/4” (88.3cm) with the leveling 

legs extended. The 30” wide product (8SWCE), have a center leg 

at the rear of the cabinet that must also be used to stabilize the 

cabinet. (See Figure 3).

To adjust the leveling legs, place the refrigerator on a solid 

surface and protect the floor beneath the legs to avoid scratch-

ing the floor. With the assistance of another person, lean the 

refrigerator back to access the front leveling legs. Raise or lower 

the legs to the required dimension by turning the legs. Repeat 

this process for the rear by tilting the refrigerator forward using 

caution to prevent the door from opening. On a level surface 

check the refrigerator for levelness and adjust accordingly.

The front grille (toe kick) screws may be loosened and  adjusted 

to the desired height. When adjustment is complete tighten the 

two toe kick screws. (See Figure 4).

4

Do not obstruct the front grille. The openings within the front 

grille allow air to flow through the condenser heat exchanger. 

Restrictions to this air flow will result in increased energy usage 

and loss of cooling capacity. For this reason it is important this 

area to not be obstructed and the grille openings kept clean. 

AGA MARVEL does not recommend the use of custom made 

grilles as air flow may be restricted because of inadequate open-

ings. (See Figure 2).