Frigidaire FFTA1233Q2 Istruzione Sull'Installazione

4

1. Remove existing 

NOTE: You may need to drill holes in flange of existing sleeve to match
new rear grille 

rear grille as shown on Page 3 of this manual and 

replace with provided louvered rear panel. Install as shown here.

2. Attach(1)1" x 3/8" x 25" long seal in the center at the top of the sleeve.

Remove the backing paper and press into position.

3. Attach(2)1" x 3/8" x 14" seals to the left and right sides of the sleeve.

6.  Gently slide unit into sleeve.

8. Remove the plastic washer from the screw.

9. Screw and attach the other end of the ground wire from sleeve to the

unit as shown in picture. Make sure that the toothed washer is against
the cabinet.

10. Slide the unit completely to the rear to ensure a good seal, making
      sure the ground wire does not become tangled.

7. Before sliding all-the-way back, remove 2nd screw from fron on left
     side of unit.

4.  Cut(2)1" x 3/8" x 25" long seals to 14" long each and attach to the 

vertical sections of the grille as shown.

5. Attach (2) 4    " x 3    " x 1   " centering/support blocks one on each 
     side wall. Place in center of side wall with the tapered end facing the
     opening.

1

2

1

2

1

2

"

11. Seal & Frame the unit as described on the last page of these 
      instructions.

12. If you have difficulty with mounting the grill to the sleeve, follow the
      instructions for direct mounting on Page 13.

4.5"

4"

80º

50º

50º

Rear Louvers

80º

Top View

4.5"

4"