Vinotemp VT18PTED2Z Manuale Proprietario

•  Remove all packing material before using your cooler. Check to be sure all parts are included and 

that the cooler is in good condition. 

•  IMPORTANT: Before connecting the unit to a power source, let it stand upright for approximately 24 

hours. This will reduce the possibility of a malfunction in the cooling system from handling during 
transportation.  

•  Clean the interior surface with lukewarm water using a soft cloth before first use. 

•  This unit is designed for freestanding installation and indoor use only. Position the unit in a dry and 

well-ventilated place. Avoid placing the wine cooler near any source of heat or moisture, or in direct 
sunlight. Do NOT install the unit in a location with an ambient temperature that will fall below 60°F.  

•  When positioning the cooler, 6 inches of space at the back and 10-12 inches of space on both sides 

are suggested to ensure proper air circulation to cool the cooling system. There also must be 
unlimited clearance at the top of the cooler to ensure proper air circulation. 

•  This unit is designed for freestanding installation only. It is not designed to be installed under a 

counter, inside a cabinet, or in any location that does not allow the proper clearance on all sides, as 
stated above.  

•  Place the cooler on a solid, level surface strong enough to support it when it is fully loaded. To level 

the wine cooler, adjust the front leveling legs at the bottom of the wine cooler. To ensure vibration and 
noise-free operation, do not install on carpet. 

•  For best performance it is recommended that you install the appliance in a location with an ambient 

temperature of 60°F -80°F. If the ambient temperature is above or below recommended temperatures, 
the performance of the unit may be affected. 

•  Plug the wine cooler into an exclusive, properly installed-grounded wall outlet. 

•  Upon plugging the cooler into an electrical outlet, let the unit run for at least 30 minutes before making 

any adjustments. 

 
 
 

The wine cooler has an electric temperature control panel and two temperature zones. When first turned 
on, the LCD will show the ambient temperature, followed by the internal cabinet temperature.  

 

Used to raise (warm) the corresponding zone set temperature by 1°C or 1°F. 
 

Used to lower (cool) the corresponding zone set temperature by 1°C or 1°F. 
 
°C/°F Selector 
Used to select the temperature display setting in degrees Fahrenheit or degrees Celsius. To change the 
temperature from Fahrenheit to Celsius or from Celsius to Fahrenheit, touch this button. 
 

8