Viking RVEWD330WH Guida All'Installazione
9
8
General Information
• When installing this unit directly below
other units, only install with Viking built-
in products.
in products.
• Remove warming drawer carefully from
carton. Remove all loose packaging and
accessories.
accessories.
• It is the responsibility of the installer to
comply with local codes. If no local
codes are applicable, wire in accordance
with the National Electrical Code,
ANSI/NFPA-70 – latest edition.
codes are applicable, wire in accordance
with the National Electrical Code,
ANSI/NFPA-70 – latest edition.
• This appliance is not fused. Protect
with a proper sized fuse or circuit
breaker and a GFI for outdoor models.
breaker and a GFI for outdoor models.
• Line disconnect switch, circuit breaker,
GFI (for outdoor models) or plug/
receptacle of power cord connection
should be readily accessible to the
operator.
receptacle of power cord connection
should be readily accessible to the
operator.
• Ground unit per applicable electrical
codes.
• Any installation not matching the
specifications discussed in these
instructions will void the manufacturer’s
warranty.
instructions will void the manufacturer’s
warranty.
READ AND FOLLOW ALL WARNING
AND CAUTION INFORMATION
WHEN INSTALLING THIS
APPLIANCE.
AND CAUTION INFORMATION
WHEN INSTALLING THIS
APPLIANCE.
Moving, Handling and Unpacking
Remove and discard all packing materials,
including cardboard and tape on the
outside and inside of the warming drawer.
including cardboard and tape on the
outside and inside of the warming drawer.
Some stainless steel parts may have a
plastic protective wrap which must be
peeled off. The interior should be washed
thoroughly with hot, soapy water to remove
film residues and any dust or debris before
being used, then rinsed and wiped dry.
Solutions stronger than soap and water are
rarely needed.
plastic protective wrap which must be
peeled off. The interior should be washed
thoroughly with hot, soapy water to remove
film residues and any dust or debris before
being used, then rinsed and wiped dry.
Solutions stronger than soap and water are
rarely needed.
Installation
1
2
1
2
Pull out warming drawer
pan until fully extended.
pan until fully extended.
Slide finger along right and left side
until you reach the black hand latches (located at the
front of the rails). Pull up on both the right and left
latches and pull out drawer pan support.
2”
(5.1 cm)
2”
(5.1 cm)
Electrical opening
(from rear)
3
2
1
1
4
Feed supply cord up through
hole in rear of warming drawer.
1
2
5
Remove strain relief bracket and mounting
screws on the terminals.
Attach the white (neutral) and black (line) lead
terminals. Attach ground wire to the
center terminal.
1
2
6
Push supply cord toward terminal
block to relieve strain, reattach supply cord strain relief
bracket over supply cord.