Marvel 8SWCEBSGLL Istruzione Sull'Installazione

Hardwood

1/8” (3.2mm) Diameter. Pilot Hole

Softwood

7/64 (2.8mm) Diameter. Pilot Hole

Table C

If your refrigerator has a door lock proceed to Step 7. If your 

refrigerator does not have a door lock proceed to Step 9.

Locate and mark with a pencil the location of the lock hole on 

the overlay panel, this is the hole  in the top corner of the handle 

side of the door. Remove the clamp and remove the overlay 

panel from the door. On the backside of the panel where you 

marked the lock location drill a 13/16” (20.5mm) diameter 

counter bore 7/16” (11.0mm) deep into the overlay panel. Drill a 

15/32” (12.0mm) diameter hole through the overlay panel cen-

tered on the counter bore being careful not to splinter the wood 

on the face side of the panel. (See Figure 12).

Two (2) lock extensions are supplied with the lock. Use the lon-

ger extension for a 3/4” thick overlay panel and the shorter one 

for a 5/8” thick panel. Assemble the lock extension, cam stop 

washer, spring washer, and set screw  to the lock as shown in 

Figure 12 and 13. Install this assembly into the overlay panel and 

secure with the retaining nut using a 15mm socket. Make sure 

the key slot in the lock is vertical.

Figure 12

SECTION A-A 

SCALE 1 : 1

LOCK

NUT

BRASS EXTENSION

CAM

PHILLIPS SCREW

13/16 COUNTER

BORE 7/16 DEEP

15/32 HOLE

3/4 INCH

WOOD PANEL

SPRING WASHER

INNER

DOOR

14-5/16”

(36.35cm)

30-5/16”

(76.99cm)

23-7/16”

(59.54cm)

30-5/16”

(76.99cm)

29-7/16”

(74.78cm)

30-5/16”

(76.99cm)

23-7/16”

(59.54cm)

30-5/16”

(76.99cm)

Table B

Glass Door Models

Top Hinge

Adapter

Hole in hinge

adapter

Door

Overlay panel

Hole in bottom

hinge adapter

Figure 11

20

Set the overlay panel on the door front, align the edges, and 

clamp together. Clamp the panel firmly but be careful not to 

damage the door or the panel. Mark center of hinge adapter 

hole on wood panel, top and bottom. (See Figure 11). Remove 

wood panel from door and drill 5/16” (8mm) diameter clearance 

holes into the overlay panels 3/4” (20mm) deep. These will be 

clearance holes for the top and bottom hinge pins. 

This is also a convenient time to locate and drill the holes for 

your handle. Most often the handle is to match that of the sur-

rounding cabinetry. If your handle attaches from the back-side 

of the custom panel, locate the mounting holes while the panel 

is attached to the door and cabinet. After the panel is removed 

from the door, drill the mounting holes from the front, to the 

recommended diameter of the handle manufacturer. Counter 

bore the back-side of the panel so the screw heads do not inter-

fere with the surface of the door.

Re-clamp the panel to the door per step 5 and drill the screw 

pilot holes for attaching the overlay panel to the door. Select 

the size of the hole from Table C. Be careful not to drill the pilot 

holes through the overlay panel, (1/2” (12.7mm) deep for 3/4” 

(19mm) and 5/8” (15.7mm) panels ).