Maytag MFC2062DEM Utilizzo E Cura

Pagina di 72
16
Water Filtration System
The water filter is located in the upper right-hand corner of the 
refrigerator compartment. 
Water Filter Status Lights
When a water filter has been installed in the refrigerator the water 
filter status lights will remind you when it is time to order and 
replace your water filter. 
The Order light (yellow) will illuminate when 90% of the volume 
of water for which the filter is rated has passed through the 
filter OR 5 months have passed since the filter was installed. 
The Replace light (red) will illuminate when the rated volume of 
water has passed through the filter OR 6 months have passed 
since the filter was installed. A new water filter should be 
installed immediately when the Replace light is illuminated.
The disposable water filter should be replaced at least every 
6 months OR earlier if the flow of water to your water dispenser or 
ice maker decreases noticeably.
Reset Water Filter Status
After replacing the water filter, press and hold Reset Filter or Filter 
Reset (depending on your model) for 3 seconds. The Order and 
Replace indicator lights will blink and then go off when the system 
is reset. See “Using the Controls.” 
Replacing the Water Filter
To purchase a replacement water filter, model UKF8001AXX-750 
or UKF8001AXX-200, see “Accessories.”
IMPORTANT: Air trapped in the water system may cause water 
and filter to eject. Always dispense water for at least 2 minutes 
before removing the filter or blue bypass cap. 
1. Turn filter counterclockwise to remove.
2. Remove sealing label from replacement filter and insert the 
filter end into the filter head.
3. Turn the filter clockwise until it stops. Snap the filter cover 
closed.
4. Flush the water system. See “Water Dispenser” or “Water and 
Ice Dispenser.”
NOTE: The dispenser feature may be used without a water filter 
installed. Your water will not be filtered. If this option is chosen, 
replace the filter with the blue bypass cap.
REFRIGERATOR CARE
Cleaning
Both the refrigerator and freezer sections defrost automatically. 
However, clean both sections about once a month to avoid 
buildup of odors. Wipe up spills immediately.
IMPORTANT:
Because air circulates between both sections, any odors 
formed in one section will transfer to the other. You must 
thoroughly clean both sections to eliminate odors. To avoid 
odor transfer and drying out of food, wrap or cover foods 
tightly.
For stainless steel models, stainless steel is corrosion-
resistant and not corrosion-proof. To help avoid corrosion of 
your stainless steel, keep your surfaces clean by using the 
following cleaning instructions.
To Clean Your Refrigerator:
NOTE: Do not use abrasive or harsh cleaners such as window 
sprays, scouring cleansers, flammable fluids, muriatic acid, 
cleaning waxes, concentrated detergents, bleaches or cleansers 
containing petroleum products on exterior surfaces (doors and 
cabinet), plastic parts, interior and door liners or gaskets. Do not 
use paper towels, scouring pads, or other harsh cleaning tools.
1. Unplug refrigerator or disconnect power.
2. Hand wash, rinse, and dry removable parts and interior 
surfaces thoroughly. Use a clean sponge or soft cloth and a 
mild detergent in warm water. 
3. Clean the exterior surfaces.
Painted metal: Wash painted metal exteriors with a clean, 
soft cloth or sponge and a mild detergent in warm water. 
Rinse surfaces with clean, warm water and dry immediately to 
avoid water spots.
Stainless steel: Wash stainless steel surfaces with a clean, 
soft cloth or sponge and a mild detergent in warm water. 
Rinse surfaces with clean, warm water and dry immediately to 
avoid water spots. 
NOTE: When cleaning stainless steel, always wipe in the 
direction of the grain to avoid cross-grain scratching. 
4. There is no need for routine condenser cleaning in normal 
home operating environments. If the environment is 
particularly greasy or dusty, or there is significant pet traffic in 
the home, the condenser should be cleaned every 2 to 
3 months to ensure maximum efficiency.
If you need to clean the condenser:
Remove the base grille.
Use a vacuum cleaner with a soft brush to clean the grille, 
the open areas behind the grille and the front surface area 
of the condenser.
Replace the base grille when finished.
5. Plug in refrigerator or reconnect power.
Do not use with water that is microbiologically unsafe or 
of unknown quality without adequate disinfection before 
or after the system. Systems certified for cyst reduction 
may be used on disinfected waters that may contain 
filterable cysts.
WARNING
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.