Maytag MFW2055DRE Scheda Tecnica

The refrigerator is not connected to a 
water supply or the water supply 
shutoff valve is not turned on 

Connect the refrigerator to the water supply and turn the 
water shutoff valve fully open.

There is a kink in the water source line

A kink in the water line can reduce water flow from the water 
dispenser and result in hollow or irregular shaped ice. 
Straighten the water source line. 

The refrigerator has just been installed

Flush and fill the water system. See “Water Dispenser.”

The water pressure to the house is not 
at or above 30 psi (207 kPa)

The water pressure to the house determines the flow from 
the dispenser. See “Water Supply Requirements.”

A reverse osmosis water filtration 
system is connected to your cold 
water supply

A reverse osmosis water filtration system can decrease water 
pressure. See “Water Supply Requirements.”

A water filter is installed on the 
refrigerator

Remove filter and operate dispenser. If water flow increases, 
the water filter may be clogged or incorrectly installed. 
Replace filter or reinstall it correctly.

The refrigerator door is not closed 
completely

Close the door firmly. If it does not close completely, see 
“The doors will not close completely.”

The refrigerator doors were recently 
removed

Make sure the water dispenser wire/tube assembly has been 
properly reconnected at the top of the refrigerator door. 
See “Remove and Replace Refrigerator Doors and Drawer 
Front.”

NOTE: A few drops of water 
after dispensing is normal.

The glass was not held under the 
dispenser long enough 

Hold the glass under the dispenser 2 to 3 seconds after 
releasing the dispenser lever.

The refrigerator has just been installed

Flushing the water system removes the air from the lines 
which causes the water dispenser to drip. Flush the water 
system. See “Water Dispenser.”

The water filter was recently changed

Flushing the water system removes the air from the lines 
which causes the water dispenser to drip. Flush the water 
system. See “Water Dispenser.”

The water line connections were not 
fully tightened 

See “Connect the Water Supply.”

Recently removed the doors and did 
not fully tighten water line connection

See “Remove and Replace Refrigerator Doors and Drawer 
Front.”

NOTE: Water from the 
dispenser is only chilled to 
50°F (10°C). 

The refrigerator has just been installed

Allow 24 hours after installation for the water supply to cool 
completely.

A large amount of water was recently 
dispensed

Allow 3 hours for the water supply to cool completely.

Water has not been recently 
dispensed

The first glass of water may not be cool. Discard the first 
glass of water dispensed.

The refrigerator is not connected to a 
cold water pipe

Make sure the refrigerator is connected to a cold water pipe. 
See “Water Supply Requirements.”