Maytag MGT8655XB-BL Guida All'Installazione

1. If range height adjustment is necessary, use a wrench or 

pliers to loosen the 4 leveling legs.

This may be done with the range on its back or with the range 
supported on 2 legs after the range has been placed back to 
a standing position.

NOTE: To place range back up into a standing position, put a 
sheet of cardboard or hardboard in front of range. Using 2 or 
more people, stand range back up onto the cardboard or 
hardboard.

2. Adjust the leveling legs to the correct height. Leveling legs 

can be loosened to add up to a maximum of 1" (2.5 cm). A 
minimum of 

³⁄₁₆" (5.0 mm) is needed to engage the anti-tip 

bracket.

NOTE: If height adjustment is made when range is standing, 
tilt the range back to adjust the front legs, then tilt forward to 
adjust the rear legs.

3. When the range is at the correct height, check that there is 

adequate clearance under the range for the anti-tip bracket. 
Before sliding range into its final location, check that the anti-
tip bracket will slide under the range and onto the rear 
leveling leg prior to anti-tip bracket installation.

1. Remove the anti-tip bracket that is taped inside the upper 

oven with the package containing literature.

2. Determine which mounting method to use: floor or wall.

If you have a stone or masonry floor you can use the wall 
mounting method.

3. Determine and mark edge of range in the cutout space. The 

mounting bracket can be installed on either the left side or 
right side of the cutout. Position mounting bracket in cutout 
so that right (or left) edge of the bracket is 

¹⁵⁄₁₆" (2.4 cm) from 

the marked edge of the range, as shown.

4. Drill two 

¹⁄₈" (3.0 mm) holes that correspond to the bracket 

holes of the determined mounting method. See the following.

5. Using a Phillips screwdriver, mount anti-tip bracket to the wall 

or floor with the two #12 x 1

⁵⁄₈" screws provided.

¹⁵⁄₁₆" (2.4 cm)

⁵⁄₈" screws

⁵⁄₈" screws