Philips 55PFL4609/F7 Manuale Utente

4 Use your TV

Switching on your TV and putting it in Standby
mode

Remote Control

To Turn the TV On from Standby or Off to Standby

●

Press B on the Side panel or the Remote Control.

Note(s)

●

Energy Consumption contributes to air and water pollution. When the AC Power Cord
is plugged in, your TV consumes energy with a very low standby Power Consumption.

Adjusting Volume

Remote Control

To decrease or increase Volume

●

Press VOL J / K on the Side panel or press VOL + / – on the Remote
Control.
VOL J (–) : Volume Down
VOL K (+) : Volume Up

To mute or unmute sound

●

Press V on the Remote Control to mute the sound.

●

Press V again or VOL + / – to recover the original sound.

Switching Channels

Remote Control

To select Channels by using CH H / I or CH + / –

●

Press CH H (Up) / I （Down) on the side panel or press CH + / – on
the Remote Control.

To select Channels by using the NUMBER buttons

Digital TV Operation

●

For Digital channels, press a number followed by a dot “•” and the
corresponding sub channel number.

–

When selecting Digital channel 11.1
Be sure to press • before entering the subchannel number.

Cable / NTSC (Analog) TV Operation

–

When selecting Cable or Analog channel 11

Press PREV.CH to return to the previously viewed channel.

Note(s)

●

To select the non-memorized channels, use the NUMBER buttons.

●

Channel not available or No Signal will appear on the TV screen after the subchannel
broadcast is over.

●

Audio Only message will appear on the TV screen, when you receive only sound signal.

English

Continued on next page.