Philips Hand blender HR1379/00 HR1379/00 Manuale Utente
Codici prodotto
HR1379/00
9
The chopper is intended for chopping ingredients such as nuts, meat, onions,
hard cheese, boiled eggs, garlic, herbs, dry bread etc.
1
Put the chopper blade unit in the chopper bowl (Fig. 9).
2
Put the ingredients in the chopper bowl.
- See the table for the recommended quantities and processing times.
chopping quantities and processing times
Ingredients
Chopping quantity
(max.)
Time (max.)
Onions
200g
5sec.
Meat & fish
200g
10sec.
Boiled eggs
2 eggs
4sec.
Herbs
30g
10sec.
Almonds
200g
30sec.
Dry bread
80g
30sec.
Parmesan cheese
200g
20sec.
Dark chocolate
100g
20sec.
Ice cubes*
6 pieces
10sec.
* Note: Use the serrated blade unit to crush ice.
3
Put the chopper coupling unit on the chopper bowl (Fig. 10).
4
Fasten the motor unit onto the coupling unit (‘click’) (Fig. 11).
5
Press and hold the unlock button (1) and then press and hold the
power-on button (2) within 2 seconds (Fig. 7).
Note: If you do not press the power-on button within 2 seconds, the charging
light flashes red and the appliance remains locked. To unlock the appliance,
repeat step 5.
, The appliance starts to operate.
- Release the unlock button when the appliance starts to operate.
- When you release the power-on button, the appliance switches off.
- If you want to pulse chop, keep the unlock button pressed and press
the power-on button a few times in quick succession.
- If the ingredients stick to the wall of the chopper bowl, loosen them
with a spatula or add some liquid.
- After processing one batch, let the appliance cool down to room
temperature before you continue processing.
6
Detach the chopper after use and clean it (see chapter ‘Cleaning’).
cleaning (Fig. 12)
Do not immerse the motor unit, the charging stand, the adapter and the
chopper coupling unit in water.
Do not touch the blades when you clean them. They are very sharp.
Do not touch the blades when you clean them. They are very sharp.
1
Press the release button on the motor unit (1) to remove the blender
bar or chopper coupling unit (2). (Fig. 13)
2
Disassemble the rest of the parts.
Tip: You can also clean the blade of the blender bar while it is still attached to
the motor unit. Immerse the blade guard in warm water with some washing-up
liquid and let the appliance run for a while.
Tip: You can also remove the rubber rings from the chopper bowl for extra
Tip: You can also remove the rubber rings from the chopper bowl for extra
thorough cleaning.
3
See the separate cleaning table for further instructions.
storage
1
Keep the charging stand plugged in continuously and store the
appliance in the charging stand. This ensures that the appliance is
always ready for use.
2
Store the mains cord by winding it round the reel in the bottom of
the charging stand.
9
EnglisH