HP (Hewlett-Packard) HP-UX 11i v2 Manuale Utente
Configuring mrouted
How to Configure mrouted
Chapter 2
32
You can use the
phyint
command to disable multicast routing on the
physical interface identified by the local IP address,
local-addr
(see
metric
or
threshold
with the
specified physical interface. Alternatively, you can replace the local IP
address,
address,
local-addr
, with the interface name, such as
lan0
. If
phyint
is
attached to multiple IP subnets, use the
altnet
option to describe each
additional subnet (one
altnet
option for each subnet).
tunnel
You can use the
tunnel
command to establish a tunnel link between the
local IP address,
local-addr
, and the remote IP address,
remote-addr
(see Figure 2-1). You can also use this command to associate a nondefault
metric
or
threshold
value with the tunnel. You can replace the local IP
address,
local-addr
, with the interface name, such as
lan0
. Similarly,
you can replace the remote IP address,
remote-addr
, by a host name,
but only if the host name has a single IP address associated with it.
Before you can use a tunnel, it must be set up in the
Before you can use a tunnel, it must be set up in the
mrouted
configuration files of both the
mrouted
routers participating in the
tunnel.
mrouted
3.8 does not support the
srcrt
option. (It provided
backward compatibility with older versions of
mrouted
that implemented
IP multicast datagram encapsulation using IP source routing.)