Vermont Casting ODGSR42A Manuale Utente

11

An optional weather enclosure is available to protect 
the burner when not in use.

CAUTION: Do not use the weather enclosure 
if the unit has glass doors installed.

1.  Turn the unit OFF and allow to cool.
2.  Grab the weather enclosure by the handle(s).
3.  Slide the top of the weather enclosure up between 

the back of the surround top and the screen rail. 
(Fig. 17)

4.  Push the bottom of the weather enclosure into the 

firebox just enough to clear the valve access cover 
and set down. (Fig. 18)

KT457

place we top

4/1/04  djt

KT457

Fig. 17  Place top of weather enclosure between surround top 
and screen rail.

Surround Top

Weather Enclosure

Screen Rail

KT458

place we bottom 

4/1/04  djt

Screen

Hearth Brick

Valve Access Cover

KT458

Fig. 18  Push bottom of weather enclosure into firebox.

An optional stainless steel hood is available for both the 
ODGSR36A  and ODGSR42A.

Installation Instructions:
1.  Turn the unit off and allow to cool.
2.  Place the hood so the 2⁵⁄₈" (67 mm) slot clears the 

sensor plate located under the fireplace opening on 
the top left side. (Fig. 19)

3.  Secure the hood to the unit using the three (3) slots 

in the hood and the pilot holes in the unit with the 
stainless steel sheet metal screws provided. (Fig. 
19) 

4.  Align the sides of the hood so the pilot holes on the 

right and left sides of the unit are exposed through 
the slots on the ends of the hood. Secure using the 
remaining stainless steel sheet metal screws. (Fig. 
19)

������
����������
����

Stainless 

Steel Hood

Stainless 

Steel Sheet 

Metal Screws 

(5)

Sensor Plate Slot

FP1635

Fig. 19  Secure stainless steel hood with five (5) sheet metal 
screws.