Hobie Tiger Manuale Utente
11
Attach the bridle wires to the bow tangs.
Mast Set-up
Lay the mast on top of the boat with the sail track to
the bottom and the mast base toward the bows.
Place padding under the mast to prevent scratching.
the bottom and the mast base toward the bows.
Place padding under the mast to prevent scratching.
1
Lay the shroud wires and trapeze wires down each
side of the mast. Secure the trapeze wires temporarily
near the base of the mast.
side of the mast. Secure the trapeze wires temporarily
near the base of the mast.
2
Ensure that the shroud anchor pins are sealed, tight
and pointing at 90° to the centreline of the hull. Attach
the twist toggles to the anchor pins using the clevis
pins and rings. If you have the optional spinnaker kit
and pointing at 90° to the centreline of the hull. Attach
the twist toggles to the anchor pins using the clevis
pins and rings. If you have the optional spinnaker kit
use the 6-mm bow shackles provided instead of the
clevis pins
.
Attach the stay adjusters to the twist toggles with the
clevis pins and rings.
Attach both shrouds into the top hole of the respective
stay adjusters. This is only a temporary position for
Attach the stay adjusters to the twist toggles with the
clevis pins and rings.
Attach both shrouds into the top hole of the respective
stay adjusters. This is only a temporary position for
3
raising the mast.
Now, attach the jib furler to the bridle wires.
NB
: Ensure that the hole in the furler housing is facing
towards the front crossbar. Now also is a good time to
roll some line onto the furler drum. Leave enough line
unfurled to reach the front crossbar mounted furler
cleat.
4
5