Philips WP3810 Manuale Utente

  

 Remove the aerator cap from the tap. Take out the original adapter 

and screw the matching adapter (C-type) onto the tap through the 

attachment nut.  (Fig. 14)

  

 Tighten the adapter further with a coin (Fig. 15).

  

 Firmly screw the attachment nut onto the water purifier 

housing (Fig. 16).
installation d-type adapter

For taps other than A, B or C.  (Fig. 17)

 1 

 Remove the attachment nut and the adapter from the water 

purifier housing (Fig. 18).

  

 Take out the original adapter and screw the D-type adapter onto 

the water purifier housing.  (Fig. 19)

  

 Push the water purifier housing onto the tap from below and 

tighten the 4 screws evenly (Fig. 20).

  

 Screw the attachment nut firmly onto the water purifier 

housing (Fig. 21).

Make sure the rubber washer is firmly pushed against the tap to prevent 

water leakage.

 1 

 Make sure the tap is closed.

  

 Set the water selection lever to the unfiltered stream 

position (Fig. 22).

  

 Tilt the filter cartridge 90° backwards and insert it into the water 

purifier housing.  (Fig. 23)

  

 Pull the cartridge upwards until it is in upright position.  (Fig. 24)

 5 

 Air trapped inside the filter cartridge affects the flow rate of the 

filtered water. To avoid this, slightly open the tap and let water run 

through the filter cartridge for 30 seconds. The slow water flow 

forces out any air that is trapped inside the filter.

-

10