Philips 3164965063 Manuale Utente

Pagina di 72
3
MOUNT THE MICROWAVE
OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN. 
NOTE: 
If your cabinet is metal, use the nylon 
grommet around the power cord hole to prevent 
cutting of the cord.
NOTE:
We recommend using filler blocks if the 
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are 
not used, case damage may occur from 
overtightening screws.
Insert a self-aligning screw through top center 
cabinet hole. Temporarily secure the oven by 
turning the screw at least two full turns after the
threads have engaged(It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
Rotate front of oven
up against cabinet 
bottom.
NOTE:
When mounting the
microwave oven, thread
power cord through hole in
bottom of top cabinet. Keep
it tight throughout Steps
1–3. Do not pinch cord or
lift oven by pulling cord.
Lift microwave, tilt it
forward, and hook
slots at back bottom
edge onto four lower
tabs of mounting
plate.
1
CHECK FOR PROPER
DAMPER OPERATION
Exhaust Adaptor
Blower Plate
Damper
Back of
Microwave
Make sure tape securing damper is removed and
damper pivots easily before mounting microwave.
You will need to make adjustments to assure proper
alignment with your house exhaust duct after the
microwave is installed.
A3.
 
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
TOP EXHAUST 
Secure blower unit to microwave with the screw
5
removed in Step 1. Make sure the screw is tight.
Replace blower plate with the screw removed in
Step 1. Make sure the screw is tight.
Back of
Microwave
6
7
Back of
Microwave
Guide
Adaptor
Locking Tab
damper swings freely.
Attach the exhaust adaptor to the top of the
blower plate by sliding it into the guides of the 
blower plate.
Push in securely until it is in the locking tabs. 
Take care to assure that the damper hinge is 
installed so that the
A4.
A5.
Installation Instructions
EN-14
IMPORTANT: Do not grip or use the handle
or heat shield during installation. Do not 
remove the cardboard spacers between the 
heat shield and door.