Smeg A1-6 Manuale Utente

Pagina di 31
 
 
Instructions for the user
 
 
50
 
Cooking start: as well as setting a cooking duration time, the user can 
also set the cooking start time (up to 12 hours after the current time). To 
set the cooking start/end time, proceed as follows. 
 
Set the cooking duration time as described in the previous point. 
Within 6/7 seconds after the last time the 
 or 
 keys are 
pressed, press the 
 key to set the cooking start time. The display 
will show the current time with the inside segments indicating the 
cooking end time illuminated. Use the 
 and 
 keys to set the 
cooking start time. 
6/7 seconds after the last time a key is pressed, the display will 
show the current time and the cooking start and end times, indicated 
by the illuminated inside segments.  The segments on the display 
will be constantly on until the current time is the same as the 
cooking start time; as soon as the current time reaches the cooking 
start time set, all the inside segments will start to flash, indicating 
that the oven has started cooking. 
When the end of the cooking time is reached, the timer will switch 
off the oven heating elements, the beeps will start and the numbers 
on the dial will flash. 
To reset the entire program set, keep the central key 
 pressed for 
1 or 2 seconds: if cooking has already started the oven will have to 
be switched off by hand. 
The image on the right shows an example of 
programming: the current time is 7.06 and 
cooking is programmed to start at 8 o'clock 
and finish at 9. 
At 8 o'clock, the inside segments between 8 
and 9 will start to flash and the hour pointer will 
remain still. 
 
Caution: for the oven to start cooking after the programming 
procedure just described, the thermostat and function selector must 
be properly set on the temperature and function required. 
 
5.3.4
 
"DEMO" Function 
Models with analogue/digital programmer feature a "DEMO" function 
which deactivates the heating elements while leaving the other functions 
unchanged. To activate it, simply press the 
 and 
 keys for 3/4 
seconds. A confirmation beep will inform the user that the function is 
active. To deactivate it, simply repeat the same procedure.