Anetsberger Brothers MX-14-2AA Manuale Utente

10

Installing your 

ANETS  Fryer requires the fol-

lowing procedure, after its legs or casters are pro-
perly attached and  it is in its desired location.

1. Ensure that the gas control valve knob in the

fryer has its OFF position next to the valve
mark.

2. Ensure that the gas supply inlet line valve is

closed (handle crosswise to the line direction).

3. Ensure that the circuit breaker dedicated to

this fryer is OFF and that all fryer controls are
set to OFF.

4. Connect the ¾” gas supply line to the gas line

adapter on the lower rear of the fryer.

5. Open the gas supply line valve (handle in-line

with line direction); then, confirm that all gas
supply line joints and couplings are free of
leaks using soap suds or a leak-check solu-
tion, after the fryer is in its desired location.

6. Plug the fryer’s electric power cord plug into

the receptacle specified for this fryer.   Switch
the circuit breaker  to ON.

7. Refer to Fryer Operating Instructions to

begin using your 

ANETS  Fryer.

      (Continued)

NOTE:  This movement-limiting de-
vice is to be furnished and in-
stalled  by the fryer’s installing
contractor before the fryer is con-
nected to the gas line at its desired
location.

1. Install one restraining device connector into

the structure wall directly behind the fryer’s
desired location, as shown in Figure 2.

2. Install one restraining device connector on the

rear panel of the fryer very close to the quick-
disconnect device on the end of the fryer’s gas
line.
NOTE:  Avoid interfering with the lift
mechanism,  on AA models.

3. Attach one end of the restraining cable to the

wall connector.  Attach the other end to the
fryer connector.

4. Confirm that the fryer cannot move far enough

away from the wall to cause excessive move-
ment of the flexible gas line or its associated
connectors.

!

DO NOT use a flame to check for leaks.

!