Anetsberger Brothers MX-14-2AA Manuale Utente

9

    (Continued)

1. Move the fryer to its desired location.

2. Determine whether the fryer tends to wobble

or rock when in its desired location.  If it
does, perform steps 3 through 9.   If it does
not, skip to step 10, then proceed to the
Installation Instructions.

3. Determine which caster requires adjustment

and the approximate amount of change
required to level the fryer.

4. Position the side of the fryer on the ship-

ping carton, exposing the bottom of the fryer
with the caster mounting plates (Figure 4).

5. Completely unscrew the bolts holding the

caster mounting plate that requires the leveling
adjustment.  Retain the locking nuts for later
reassembly.

(Continued)

6. Reinsert each bolt through its flatwasher and

the fryer mounting bracket; next, place a
spacer of the required size on the bolt before
inserting the bolt through its mounting hole on
the caster mounting plate and screwing a
locking nut onto the bolt.

7. Repeat step 6  for all remaining bolts.

8. Tighten all four locking nuts evenly and se-

curely against the caster mounting plate and
the fryer bottom mounting bracket.

9. Return the fryer to its desired location.  Lock

the front casters to prevent fryer movement
and check again for wobbling or rocking.
Repeat steps 3 through 9 until no wobbl-
ing or rocking occurs.  When the fryer no
longer wobbles or rocks, perform step 10.

10. Perform the Fryer Restraining Device

!

Figure 4. Typical  Caster Installation