Emerson Process Management MON2000 Manuale Utente
INSTALLATION AND SETUP
2-29
MON2000
JULY 2010
Set Up GC Directory
GC Controller system interface board) for
the GC unit.
To successfully connect to the GC unit, the
To successfully connect to the GC unit, the
COM IDs specified via the File>GC
Directory and the Application>Serial Ports
dialogs must match.
more information.
7. Click the Comments cell to enter any helpful
information regarding a particular GC unit,
such as location or purpose.
8. Use the dynamic pull-down menus to select
the desired PC Port, Baud Rate, Data Bits,
Stop Bits, Parity, and Handshaking
settings.
9. Use the provided cells to input RTS On
Delay, RTS Off Delay, and Extra Delay
values.
The Extra Delay field accepts numerical
The Extra Delay field accepts numerical
values (0 to 9000 milliseconds) for
additional time to be added to the current
communication timeout delay.
10.Use the Protocol pull-down menu to select
the desired Modbus communications
protocol.
11.If you plan to connect remotely to the GC
unit via a modem or Ethernet connection,
use the Connection Type (Direct/Remote)
The following parameters support an auto-detect
setting: Baud Rate, Data Bits, Stop Bits, Parity,
Protocol.
Set any of these parameters to “?” (autodetect) and
Set any of these parameters to “?” (autodetect) and
MON2000 will conform to the settings used by the GC
unit.