Q-Logic 5802V Manuale Utente

5 – Switch Configuration

Managing Switch Configurations

59263-01  A

5-13

A

Enter the 

 Delete command in an Admin session to delete a configuration 

from the switch as shown in the following example. You cannot delete the active 
configuration nor the default configuration (Default Config).

SANbox (admin) config delete config_2

To modify a switch configuration, you must open an Admin session with the 

Start command. An Admin session prevents other accounts from making changes 
at the same time through Telnet, Enterprise Fabric Suite 2007, or another 
management application. You must also open a Config Edit session with the 

 Edit command and indicate which configuration you want to modify. If you 

do not specify a configuration name the active configuration is assumed.

The Config Edit session provides access to the Set Config commands with which 
you make modifications to the port, switch, port threshold alarm, or zoning 
configuration components as shown:

SANbox #> admin start

SANbox (admin) #> config edit

   The config named default is being edited.

SANbox (admin-config)#> set config port . . .

SANbox (admin-config)#> set config switch . . .

SANbox (admin-config)#> set config threshold . . .

SANbox (admin-config)#> set config zoning . . .

SANbox (admin-config)#> set config security . . .

The Config Save command saves the changes you made during the Config Edit 
session. In this case, changes to the configuration named Default are being saved 
to a new configuration named config_10132003. However, the new configuration 
does not take effect until you activate it with the Config Activate command:

SANbox (admin-config)#> config save config_10132003

SANbox (admin)#> config activate config_10132003

SANbox (admin)#> admin end

The Admin End command releases the Admin session for other administrators 
when you are done making changes to the switch.