Apple Foot Manuale Utente

 

PowerBook G4 (15-inch FW800) Foot Replacement  - 

 

  The glue used in this procedure can bond instantly to skin. Do not touch the 

glue. In the event of contact, review the safety instructions at the end of this document. For 

additional information, refer to the glue manufacturer:

Elmer's Products, Inc.

Columbus, OH. 43215-3799

www.krazyglue.com

1.

Place the computer upside down on a clean, lint-free cloth or other nonabrasive 

surface.

2.

Select a foot from the kit. Verify that the case plug and case foot match (refer to the 

images shown in the table). Do not use a foot that does not match. 

3.

Make sure the plug area on the bottom case is clean. If any portion of the soft rubber 

foot remains, remove it so that only the hard plastic plug is visible. 

 

  When positioning the foot, make sure the indents and bumps of the 

rubber foot match up and fit into the corresponding indents and bumps in the plug. 

This ensures a balanced and level fitting. (Note: The picture below is of a different 

foot than on your computer, and is for illustration only.)