Apple Foot Manuale Utente

PowerBook G4 (15-inch FW800) Foot Replacement -

Warning:

GLUE IS AN EYE AND SKIN IRRITANT. BONDS SKIN INSTANTLY. Do not

touch the glue at any time. Before opening the glue, review the safety instructions at

the end of this document.

Important:

The glue tube included in the kit is sealed until first use. Do not break the

seal until you are ready to use the glue. To break the seal, hold the tube upright and

away from you. Place the hollow nozzle cap on the tube and tighten it all the way

down. The tube is then ready to dispense the glue through the nozzle cap.

Apply one drop of glue to the plug on the bottom case. Do not spread the glue.

Using tweezers or needlenose pliers, carefully position the new foot so its textured

surface fits into the inner ring of the plug.

Using the end of the tweezers or pliers—not your finger—lightly press and hold the

foot in place for 30 seconds.

Before turning over the computer, allow the glue to set for at least 15 minutes.

Discard the tube of glue.

SAFETY INSTRUCTIONS:

GLUE IS AN EYE AND SKIN IRRITANT. BONDS SKIN

INSTANTLY. Contains ethyl cyanoacrylate. Avoid contact with skin and eyes. If eye or

mouth contact occurs, hold eyelid or mouth open and rinse thoroughly but gently with

water only for 15 minutes and GET MEDICAL ATTENTION. Liquid glue will sting eye

temporarily. Solidified glue may irritate eye like a grain of sand and should be treated by an

eye doctor. If skin bonding occurs, soak in acetone-based nail polish remover or warm

soapy water and carefully peel or roll skin apart (do not pull). Contact through clothing may

cause skin burn. If spilled on clothing, flush with cold water. Avoid prolonged breathing of

vapors. Use with adequate ventilation. KEEP OUT OF REACH OF CHILDREN.